Sage and Cream Sheep Crochet Mug Rug
A quiet pastoral detail can make a tea break feel slower and softer, even on a small table. This oatmeal panel, with thin sage-green stripes at the top and bottom, is sized for one mug, and a small fluffy sheep sewn on top gives it a gentle, countryside character. It is a flat, straightforward project, with no shaping in the round and no stuffing to manage.
The starting point is only the general sheep motif. This version turns it into something different: a small crochet table accent, not a knitted blanket block, worked as a plain rectangular panel with a separate bobble-textured sheep appliqué sewn on afterwards. It does not use knitting, stocking stitch, garter edges, or embroidery worked over a chart. The sheep here is built from a bobble body, a small dark head, ears, and legs, all joined by hand.
Pattern status: this is a newly drafted, untested crochet pattern. Stitch counts and row totals have been checked, but no physical sample has been made. Fit, gauge, yarn consumption, and how the appliqué sits after washing still need checking in a real sample. All three images are AI-generated concept illustrations, not photographs of a tested mug rug.

What Makes This Mug Rug Different?
The base is worked in simple rows, back and forth, so the panel stays flat and easy to measure as you go. The colour changes are only at the two ends, two sage-green rows at the top and two at the bottom, with a long oatmeal section in between. Once the first row is right, every row that follows has the same stitch count.
The sheep is not worked into the panel. Its fluffy body is made with bobble stitches, which stand up from the surface and read as wool without any extra yarn or brushing. The head, ears, and legs are small, plain pieces in a dark contrast colour, so the sheep stays clear and simple rather than fussy. Making the sheep separately means a mistake in one small piece does not mean unravelling the whole rug.
Project Details
| Detail | Draft specification |
|---|---|
| Skill level | Confident beginner |
| Terms | US crochet terminology |
| Construction | Flat rectangular panel, plus separate sewn-on appliqué pieces |
| Finished panel size | Approximately 20 cm wide x 11 cm tall, before the edge round |
| Main stitches | Single crochet, bobble stitch |
| Main colours | Oatmeal cream, sage green, cream, charcoal |
| Pattern status | Arithmetic checked; not physically crocheted or tested |
Materials and Yarn Choices
- Smooth DK or light worsted yarn in oatmeal cream: approximately 30-40 g for the panel.
- Matching yarn in sage green: approximately 10 g for the end stripes.
- Matching yarn in cream: approximately 15-20 g for the sheep body.
- Matching yarn in charcoal: approximately 10 g for the head, ears, and legs.
- A small amount of cream yarn for the eyes.
- A 4.5 mm crochet hook, adjusted for gauge and a flat, firm fabric.
- Tapestry needle, scissors, measuring tape, and removable stitch markers.
Use the same yarn family for all colours, so the panel and the appliqué pieces behave the same way when washed. A smooth cotton blend or soft acrylic makes the bobbles easy to count. A very fluffy yarn will hide the bobble texture and should not be substituted without swatching first.
The yarn amounts are provisional rather than measured sample consumption. Keep a little extra oatmeal cream available, as the panel uses the most yarn of any piece.
Gauge and Expected Dimensions
The provisional gauge is 15 single crochet stitches and 18 rows per 10 cm in single crochet fabric. Measure a swatch after letting it relax, and count the stitches across the middle of the swatch rather than at the edges. The bobble rows will feel thicker than plain rows; measure the gauge in plain single crochet, not in bobble fabric.
At this gauge, 30 stitches measure about 20 cm across. Twenty rows suggest a height of about 11 cm. Those are calculated targets rather than sample results. If your gauge is looser, the panel will be larger; if it is tighter, it will be smaller. Check the width after the first few rows, while it is still easy to restart.
To change the width, multiply your target width in centimetres by 1.5 and round to a whole stitch. For example, a 22 cm panel needs approximately 33 stitches, with a starting chain of 34. Keep that chosen stitch count throughout every row of the panel.
Abbreviations and Working Notes
| Abbreviation | Meaning |
|---|---|
| ch | Chain |
| sc | Single crochet |
| bob | Bobble stitch (see below) |
| st / sts | Stitch / stitches |
| RS | Right side, the chosen outward face |
To work a bobble: yarn over, insert the hook into the stitch, yarn over and pull up a loop, yarn over and pull through 2 loops. Repeat that sequence four more times in the same stitch, so you have 6 loops on the hook, then yarn over and pull through all 6 loops. The bobble counts as one stitch.
Chain 1 and turn before each new row of the panel and of the flat appliqué pieces. The turning chain does not count as a stitch. Work the first sc into the first actual stitch, and finish in the last actual stitch. Mark both row ends if you tend to gain or lose stitches.
Work all pieces with the same hook size unless your swatch tells you otherwise. Push each bobble gently to the right side as you work it, so the texture faces outward on the finished sheep.
The Crochet Pattern
Step 1: Crochet the Base Panel
With sage green, ch 31 for the reference size, or your chosen stitch count plus one chain.
Row 1: Sc in the second chain from the hook and in every remaining chain. 30 sts, or your chosen count.
Row 2: Ch 1, turn. Sc in every stitch across. 30 sts.
Change to oatmeal cream on the last sc of Row 2, leaving tails long enough to weave in later. Do not tie a hard knot at the colour change, where it can show through the light-coloured fabric.
Rows 3-18: Ch 1, turn. With oatmeal cream, sc in every stitch across. 30 sts in each row.
Change to sage green on the last sc of Row 18.
Rows 19-20: Ch 1, turn. With sage green, sc in every stitch across. 30 sts in each row.
You now have 20 rows altogether: 2 sage-green rows, 16 oatmeal rows, and 2 sage-green rows. Lay the panel flat without stretching and measure it before continuing. Fasten off, leaving a tail for weaving in.

Note: the process illustration shows more sage stripes than the written draft; the draft uses sage green only in Rows 1-2 and Rows 19-20.
Step 2: Crochet the Sheep Body
With cream, ch 15.
Row 1: Sc in the second chain from the hook and in every remaining chain. 14 sts.
Row 2: Ch 1, turn. Sc in the first st, bob in the next st, then repeat (sc, bob) to the end. 14 sts (7 sc and 7 bobbles).
Row 3: Ch 1, turn. Sc in every stitch across. 14 sts.
Row 4: Ch 1, turn. Bob in the first st, sc in the next st, then repeat (bob, sc) to the end. 14 sts (7 bobbles and 7 sc).
Row 5: Ch 1, turn. Sc in every stitch across. 14 sts.
Row 6: Ch 1, turn. Sc in the first st, bob in the next st, then repeat (sc, bob) to the end. 14 sts (7 sc and 7 bobbles).
Fasten off, leaving a long tail for sewing. You have a small rectangle, 14 stitches wide and 6 rows tall, with bobbles on Rows 2, 4, and 6.
Step 3: Crochet the Head and Ears
Head, with charcoal: ch 7.
Row 1: Sc in the second chain from the hook and in every remaining chain. 6 sts.
Rows 2-4: Ch 1, turn. Sc in every stitch across. 6 sts in each row.
Fasten off, leaving a tail for sewing. Make one head, 6 stitches wide and 4 rows tall.
Ears, with charcoal: ch 3.
Row 1: Sc in the second chain from the hook and in every remaining chain. 2 sts.
Row 2: Ch 1, turn. Sc in every stitch across. 2 sts.
Fasten off, leaving a tail for sewing. Make two ears, each 2 stitches wide and 2 rows tall.
Step 4: Crochet the Legs
With charcoal: ch 3.
Row 1: Sc in the second chain from the hook and in every remaining chain. 2 sts.
Rows 2-3: Ch 1, turn. Sc in every stitch across. 2 sts in each row.
Fasten off, leaving a tail for sewing. Make four legs, each 2 stitches wide and 3 rows tall.
Step 5: Sew the Sheep Together
Lay the base panel flat with the right side facing up. Place the sheep body in the centre of the panel, with its bottom edge about 3 rows above the bottom sage-green stripe, and an equal amount of oatmeal panel showing on the left and right. Pin or mark the position before sewing, and check it from a normal table distance, not only from close up.
Sew the four legs to the panel first, two near the left end of where the body will sit and two near the right end, with their top row tucked under the body position and their lower two rows showing below it. Use the charcoal tails and small whip stitches.
Sew the body over the top row of the legs, using its cream tail and small whip stitches around the edges that catch the panel without pulling it into a pucker. Work through only the top layer of the panel if you can, so the back stays neat.
Place the head at the left end of the body, overlapping the first two stitches of the body and sitting slightly above its centre, so the sheep faces left. Sew it with its charcoal tail. Place one ear on each side of the top of the head, angled slightly outward, and sew both ears with their charcoal tails.

Step 6: Add the Eyes
With cream yarn, work two small dot stitches on the head, spaced evenly and level with each other, using short straight stitches or small French knots. Keep them light and even, and do not pull them tight enough to pucker the head.
Weave in all remaining tails on the back of the panel, reversing direction once so they stay secure. Trim the tails close only after checking that no appliqué edge has lifted, especially at the legs.
More Information and Finishing Tips
Keep the Panel Flat
A panel that curls at the corners usually means the edge stitches are tighter than the middle, or the row ends have been missed. Count the stitches at the end of every few rows, and keep the turning chain loose. The bobble body will naturally sit a little higher than the panel; that is the intended texture, not a curl to flatten out.
Work one round of edge stitches only if you want a neater finish: with oatmeal cream, sc evenly around the whole panel, placing 2 sc in each corner, and join to the first sc. This is optional, and it is not counted in the 20 cm x 11 cm panel size above.
Adjust the Size With a Plan
For a wider mug rug, increase the starting chain as described in the gauge section, and keep the same 20 rows unless you also want a taller rug. For a taller rug, add oatmeal rows in the middle of the panel, in pairs, so the sage-green stripes stay at the two ends. Record the new row numbers so a second rug matches the first.
For a smaller coaster version, reduce the panel to about 24 stitches and 16 rows, and reduce the sheep body to 12 stitches wide, keeping the same bobble alternation. Treat that smaller version as a separate draft, and check its measurements before sewing the sheep on.
Choose Another Palette
Dusty blue with oatmeal gives the same sheep a cooler, quieter look, keeping the head and legs in charcoal so the face still reads clearly. Try warm grey with cream for an everyday table, with a sage-green stripe kept at the ends for a little colour. Keep all yarns in the same family, so the panel and the appliqué wash in the same way.
If you omit the eyes, the dark head against the cream bobble body still reads as a sheep at a glance. Make the first version simple and check that the appliqué sits flat before adding more detail.
Care for the Finished Rug
Follow the yarn label when washing. Reshape the panel to its flat rectangle while damp and dry flat, gently patting the bobbles back into shape. Avoid hanging it by a corner while wet, since that can stretch the panel out of shape. Keep hot mugs on the oatmeal section rather than directly on the appliqué, so the sewn edges are not repeatedly pressed and loosened.
After washing, check the appliqué edges, especially at the legs and ears. Secure a loose stitch before it works its way along an edge.
Frequently Asked Questions
Is this the same as the knitted sheep block that inspired it?
No. This is a small crochet mug rug with a sewn-on bobble sheep. It uses a different technique, a different size, and a different way of forming the sheep, and it does not reproduce the knitted block’s instructions, chart, or embroidery method.
Can a beginner make this mug rug?
It suits a confident beginner who can work single crochet, follow a simple bobble repeat, and sew small pieces together with a tapestry needle. The most important steps are keeping the panel stitch count steady and pinning the sheep in place before sewing it down.
Why use bobbles instead of plain stitches for the body?
Bobbles stand up from the surface and give the body a woolly look without extra yarn, brushing, or stuffing. Plain stitches would make the body look flat, and the sheep would be harder to tell apart from the panel at a glance.
What if my bobbles pull to the back?
Push each bobble gently to the right side as soon as you finish it, before working the next stitch. If a whole row has flipped, turn the piece over and push the bobbles through from the back, one at a time, before sewing the body to the panel.
Can I use a different yarn weight?
It will change the size and the firmness substantially, so the written measurements will no longer apply. Use the gauge section to recalculate the stitch count for your yarn, and make a swatch that includes a bobble row before starting the full panel.
Has this mug rug been physically tested?
No. The 30-stitch panel, the 20-row total, the body, head, ear, and leg counts have been checked mathematically. Gauge, yarn use, appliqué hold, and practical use still need a real crocheted sample. The images show the intended style and may differ in stitch detail or proportions.